procedure and else if statements

[sci23]

when i run this there is an error. how do i put else if statements in procedures? thanks for your help

code:

procedure die if die=die1 then drawbox(300,50,200,150,7) drawfilloval(250,100,10,10,7) elsif  die=die2 then drawbox(300,50,200,150,7) drawfilloval(285,135,10,10,7) drawfilloval(215,65,10,10,7) elsif die=die3 then drawbox(300,50,200,150,7) drawfilloval(285,135,10,10,7) drawfilloval(215,65,10,10,7) drawfilloval(250,100,10,10,7) elsif die=die4 then drawbox(300,50,200,150,7) drawfilloval(285,135,10,10,7) drawfilloval(215,65,10,10,7) drawfilloval(285,65,10,10,7) drawfilloval(215,135,10,10,7) elsif die=die5 then drawbox(300,50,200,150,7) drawfilloval(285,135,10,10,7) drawfilloval(215,65,10,10,7) drawfilloval(285,65,10,10,7) drawfilloval(215,135,10,10,7) drawfilloval(250,100,10,10,7) elsif die=die6 then drawbox(300,50,200,150,7) drawfilloval(285,135,10,10,7) drawfilloval(215,65,10,10,7) drawfilloval(285,65,10,10,7) drawfilloval(215,135,10,10,7) drawfilloval(215,100,10,10,7) drawfilloval(285,100,10,10,7) end if end die put "Rolled ", Rand.Int (die,1, 6)

[Saad]

What exactly are you trying to do?, as far as i know, you cant check if procedures are equal (Why would you anyway?)

[Jestar]

i would just make a different procedure for each die roll and call the procedure when it has the correct die roll.

[Clayton]

Why not create one procedure which takes a parameter for which value the die has been rolled?

[Jestar]

that works to