crane motor

[Hagy]

I need help with writting a turing code to make a motor control a crane to rotate back and forth through 90 degrees, and another motor to rotate bidirectionally 360 degrees to lower and raise a magnet. Can anybody help ?? Thanks hagy.

[Ultrahex]

we could help... if you were willing to state what you need help with, clearly you have not tried anything yet (or it appears from us you have not) also are these physical objects (as in through parallel port or visually graphics, which you also have not clearly stated). Also, we do not know the interface of the hardware you are using if you do not specify if it is not visual graphics.

Please Reply, with your actual intended problems, and or what you need help with.

[Hagy]

Thank you, we are using a parallel port, and turing version 4.0.3. We want to get one motor to rotate a crane 360 degrees, and a second motor to turn a spindle with a string attached to a magnet. This motor has to turn bi directionaly. We need the turning program to make the motors turn but we are not sure how to write it. The motor we are using to bring the string back up and down is a H-bridge DC motor. We also need a electro magnet to turn on so the magnet will work. Which we also dont know how to write into the code. Thanks HAGY

[chrisciscoioio]

What textbox are you using, Holtsoft has an Grade 12 engineering book that does that but adds extra features.

[Hagy]

Thank you very much. It helped a lot. Hagy